Use the Correct Size Blasting Head(s) to Maximum your Paint Removal Productivity

The advantages of having a number of head sizes to choose from is the fact that you can focus the energy of the water jets on the material being removed and not the surrounding surface. Imagine a painter that wanted to paint a 4” (10 cm) line but only had a 12” (30 cm) paint spray head. They would have to lay down 4” (10 cm) of masking on each side of where they wanted the line to be and you can easily see how 8” (20 cm) of paint would be wasted. Wasting the blasting energy with a water blaster is no different.No other water blasting equipment manufacturer offers you the extensive array of choices to optimize your productivity and minimize surface impact as well as minimize the use of water on the job site.We offer the following blasting heads: 6″, 8″, 9″, 12″, 14″, 22″ and 36″. Our ” Quick Change ” system offers the most versatile and adaptable blasting head configurations of any water blasting equipment manufacturer, allowing the operator to go from as narrow as 6” (15.2 cm) cutting path for marking removal, to a 36” (91.4 cm) path for rubber removal in less than 10 minutes. While an NLB Starjet head takes 15 bolts to remove the nozzle protector and head, the Stripe Hog has exactly zero. Spin off, Spin on. No bolts and no torquing.

 

Our new tubular heads allow you to quickly change out the spray bars and position them in an infinite number of configurations. The spray bars that would normally be in the horizontal position for road or runway removal can also be positioned vertically for barrier walls. (pics/video shown below)

Tubular_Heads_All

Stripe Hog – Road Marking Removal Stripe Hog – Road Marking Removal

Waterblasting Technologies also offers shroud and spray bar customization to your specific application needs. Our extensive options of shrouds and spray bars includes:

Tractor_All_Heads_2013

• 10” (25.4 cm) shroud for a 8” (20.32 cm) and 10” (25.4 cm) spray bars for the HT2500- Hog Rider and HT1000- Ground Hog
• 14” (35.56 cm) shroud for a 12” (30.48 cm) and 14” (35.56 cm) spray bars for the HT2500- Hog Rider and HT1000- Ground Hog
• 22” (55.88 cm) shroud for a 22” (55.88 cm) spray bar for the HT2500- Hog Rider and HT1000- Ground Hog
• 36” (91.44 cm) should for a 36” (91.44 cm) spray bar on the HT2500- Hog Rider only

GroundHog_Shrouds_All

We have recently created a new tunnel spray bar. It has a target effected removal blasting width of 8 feet (2.43 m) with 10,000 psi and 45 gallons per minute. This bar adjusts so it can spray walls, tunnels, and the bottoms of bridges.

TunellCleaner

0 replies

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published. Required fields are marked *